Bye Bra Perfect Cleavage (A-F)

Hygiene product! The right of return applies only to unopened, resaleable packaging. The product does not have a free exchange right and a fee will always be charged for the return.

Bye Bra Perfect Cleavage bras are practical, discreet bras that go well with open-necked and deep-fluted dresses or other tops that do not fit under a normal bra. They allow you to lift your breasts easily and give your bust support and a taut look without the need for a normal bra.

The Perfect Cleavage bra tape is a disposable four-tape bra solution that uses two tapes per breast. The L-tape turns the breast slightly inwards, creating a better breast support. The T-tape adds final support.

Bye Bra english language instructions. They are also water and moisture resistant, so you can even wear them under your swimsuit!

NOTE: For instructions in English, see below.

NOTE: The product is not eligible for exchange or return for hygiene reasons. Only the completely unopened package can be returned and the customer will be charged for the return of the unopened hygiene product.

Made in the Netherlands.

Before you start
:1. Clean your breasts before using Bye Bra. Remove sweat, water, grease and oil.
2. Use a mirror to help you apply the tapes.

3. Use a tape cutter to help you cut the tapes to fit. If you have A-B cup breasts, you can cut the L and T tapes in half; you will get double the amount of tape. If you have C cup breasts, cut the tapes along the dotted line. For D cup and larger, use the whole tape.
4. Think about where you will place the tape. The tape should go in the same direction as the garment you are going to wear (see tips for different styles on the back cover).

Halterneck: tapes can be placed on either side of the neck.


deep v-neck with shoulder straps: place the tapes on the shoulders.
cross-strap: tapes can be placed on the opposite side.

5. L-tape is placed first, T-tape afterwards.
6.
Both tapes should be placed on one breast first, and only then move on to placing the tapes on the other breast.

When applying the tapes:
7. Dare to lift the breasts a fair amount with the breast tapes; depending on the size of the breasts, the breasts can be lifted 8-15cm. When lifting the breasts, always hold the end of the tape with your fingers (part 4).
8.
Make sure you smooth the tape carefully after each section.
9. Place the tape section by section, starting with section 1.
10. Tapes should not be placed on the inner edge of the breast; do not overlap the inner part of the nipple shields (see picture in the instructions) so that the tapes do not show under the garment.

11.

Do not place the tape too low (see picture); place the tape at the bottom of the breast, NOT below the breast.
12.
When placing the oblong part of the tape, stretch your neck in the opposite direction and bend backwards slightly. This will stretch the skin and make it easier for you to put the tape in place.
13. Place the elongated part of the T-tape on top of the L-tape, after making sure that the L-tape has been carefully smoothed in place before.

When using tape:
14. Keep an eye on skin reactions to the tape.
If the skin becomes irritated, remove the tape immediately.

When removing the tapes:
15. Remove the tapes from the bottom up using oil or grease
. Do not forget to read the "important information for users" before applying the tape.

Tip: In addition to Bye Bra Perfect Cleavage chest tapes, use Bye Bra double-sided garment tape on your dress/top to keep the outfit in place.

The package comes with illustrated instructions in English. Take the

L-tape (L-shaped tape) in your hand and remove the protective tape from the L-tape at part 1.Avoid touching the tape with your fingers.

Take care not to double tape the tape.
- Place the L-tape part 1 on the outer and lower part of the breast (see picture) without crossing the middle part of the nipple shield.
The end of the L-tape should be on the outer edge of the breast. Carefully adhere the tape to the skin by applying gentle pressure. Make sure that the entire surface of the tape is adhered to the skin.
- Gently peel off part 2 of the L-tape from the protective film.
- Hold onto point 4 of the L-tape and pull the breast firmly upwards.

Depending on the size of the breasts, the breasts can be lifted 8-15cm. Gently press the tape into the skin. The L-tape brings the breasts slightly inwards, creating a better breast support. Hold on to section 4 of the L-tape, and repeat for section 3 of the L-tape.
- Remove the protective film from section 4, and apply pressure to the skin. Ideally, part 4 should be placed on the shoulder for better support.
- Remove the protective film from T-tape part 1 and place the T-tape over the L-tape.
Repeat for the T-tape as for the L-tape; remove the protective film at the point, and lift the chest upwards. Once both tapes are attached to the left breast, repeat the same for the right breast.

Remove the Bye Bra before sleeping. Bye Bra are hypoallergenic, but we do not recommend using them for more than 8 hours. Bye Bra after using and removing the :s, we do not recommend using them again for 72 hours. Do not use Bye Bra:on sensitive skin, wounds, scars, sunburned or sun-damaged skin, or if you are pregnant or breastfeeding.